Chapter 1 Exploded 65% (In-stock)

FIRMWARE AND INSTRUCTIONS (thanks to Cheezi aka Flash3ds Left Kidney on Proph's discord)

DON'T FORGET TO PICK UP EXTRAS!

BUILD STREAM (ALEXOTOS) | BUILD STREAM (MECHMERLIN) | DUTCHMASTERW

Quality Disclaimer

Internal streaks, blemishes and uneven anodizations that are not visible after being built are within QC expectations.

Pictures may be different than actual products due to variations of lightings. However, the designer has tried his best to capture all the finishing.

Introduction

Chapter 1 was designed to honor the material used, by making these materials visible in a sophisticated and striking way.

This is done by easily making all parts that make up the board visible in one way or another; allowing for nearly endless ways to mix and match plates, knobs, weights and your own keycaps to achieve a build that is truly what you want!

The single piece weight spans across the width of the board that creates an amazing sound - specifically for the alphas with the higher density of brass, copper or a stainless steel weight! 

The custom knob was designed to match the aesthetics of Chapter 1 and brings a totally new look and feel to keyboards with knobs!

The leaf spring plate was designed to achieve a bouncier, softer typing feel rather than being flexy. This effect works perfectly on PC and aluminium plates, with brass and copper naturally being a much stiffer.

Specifications

65%

Isolation gasket mount with leaf spring plate

6.5° typing angle

18mm front height (excluding front chamfer)

Footprint = 340mm wide x 136.5mm deep

Weight is between 1.8kg and 2.5kg depending on configuration

Arrow cluster

EC11 Rotary encoder (NOT PRE-SOLDERED ON SOLDER PCB)

ANSI and ISO plate options (6.25u only)

Solder and Hotswap PCBs

USB-C daughter board

Aluminium and Polycarbonate Case Options

Various Weight Options

Custom Knob

Package

Top, bottom and weight

PC plate as standard (ANSI/ISO)

Knob matching chosen edition

Hotswap/solder PCB + jst + db + rotary encoder

Daughterboard and encoder

Necessary screws

Gaskets, feet and silicon plate alignment pins

Hard carry case

Chapter 1 comic